Fits the following bikes:
- R1 2004+
- R6 2003+ (S models included)
- FZ1 All
- FZ8 All
- FZ6 All
- ZX6r 2003-2008
- ZX6rr 2004-2008
- ZX10r 2004-2010
- ZX12 2004-2005
- ZX14r All
All plate orders will come in pairs... two plates. Each order will also include an airbox cap, a zip-tie to help tidy up your intake area, and an Agg Racing decal.
Used to seal the ports on the valve cover for the AIS (Air Injection System).
Eliminate the popping noise from aftermarket exhaust and baffle kits!
Most importantly, to get an accurate air/fuel mixture reading when tuning the bike.
For installation, all attached reeds and other AIS/smog system pieces need to be removed completely in order for the plates to install properly. PLEASE DON'T FORGET TO REMOVE THE REED SCREWS. Without removal, the plates will not seal correctly and you will have excessive engine noise. For the occasional Kawasaki installation, the holes in the plates will need to be enlarged approximately 1mm each. This is a very simple tweak, and will allow the plate to install perfectly.
AGG Block Off Plates
Use code AGG if purchasing with a flash to receive $5 off.